General

dc-potential range

± 5V or ± 10V

compliance voltage

± 10V

maximum current

± 30 mA (typical)

max. acquisition rate

150,000 data points/s

Potentiostat (controlled potential mode)

applied dc-potential resolution

76.3 μV

applied potential accuracy

≤ 0.1% ± 1 mV offset

current ranges

100 pA to 10 mA (9 ranges)

measured current accuracy

≤ 0.1 % at Full Scale Range

measured current resolution

0.005% of current range (5 fA on 100 pA range)
0.0025% of 10 mA range

Galvanostat (controlled current mode)

current ranges

1 nA to 10 mA (8 ranges)

applied dc-current range

±6 times applied current range

applied dc-current resolution

0.0076% of applied current range (<10 mA)
0.0038% of 10 mA range

measured dc-potential resolution

78.13 μV at ±10 V (gain 1, 18-bit)
7.813 μV at ±1 V (gain 10))
0.7813 μV at ±0.1 V (gain 100)

measured dc-potential accuracy

≤ 0.05% or ±1 mV (for |E| < ±9 V)
≤ 0.2% (for |E| ≥ ±9 V)

FRA / EIS (impedance measurements)

frequency range

10 μHz to 100 kHz or 10 μHz to 1 MHz

ac-amplitude range

1 mV to 0.25 V rms, or 0.7 V p-p

GEIS (galvanostatic impedance measurements)

frequency range

10 μHz to 100 kHz or 10 μHz to 1 MHz

ac-amplitude range

0.001 x CR to 0.4 x CR (<10 mA)
0.001 x CR to 0.2 x CR (10 mA)
(CR=current range)

Electrometer

electrometer amplifier input

> 1 TΩ // 10 pF

bandwidth

1 MHz

Other

housing  

aluminium with rubber sleeve: 15.7 x 9.7 x 3.5 cm³

weight

+/- 500 g

temperature range

0 ºC ~ + 50 ºC

power supply

USB or internal LiPo battery

communication

USB and Bluetooth (Dual Mode)

battery time

> 16 hours idle time
> 5 hours idle time with BiPot module installed
> 4 hours with cell on at max. current
Extendable by means of power bank

internal storage space

8 GB
or +/- 800000 measurements incl. method parameters
(assuming 200 data points per measurement)

Auxiliary port (D-Sub 15)

analog input

± 10 V, 18 bit

analog output

0-10 V, 12 bit (1 kOhm output impedance)

4 digital outputs

0-5 V

1 digital input

0-5 V

I-out and E-out

raw output of current and potential
E-out ± 10 V (1 kOhm output impedance)
I-out ± 6 V (1 kOhm output impedance)

power

5 V output (max. 150 mA)