Application note
This high-pressure electrode is commonly used with aqueous acidic electrolytes, but due to the low resistance of the frit it can be used with standard non-aqueous electrolytes, as well. The high-pressure electrodes should be installed in the high-pressure cell using Swagelok electrode fitting 6 mm OD. Before use rinse it with deionized water and fill it up with an electrolyte (preferably 3M KCl, not included in the set) through the electrolyte inlet using a syringe with a needle. For cleaning, use detergent (dishwashing detergent with water), alcohols, or acetone, and rinse it with deionized water at the end. 

아래 이미지를 클릭하시면 큰 이미지로 보실 수 있습니다.